Networx: Learn how to move a refrigerator – the right way
If you’re wondering how to move a refrigerator, you’ve probably been picturing a couple of husky humans hauling the fridge out of your house and onto a truck. However, frequent movers (like yours truly) have learned that muscle power is just a part of the story. Moving a fridge requires careful preparation, protection, and aftercare to avoid damaging any delicate components.
Prep and protection
1. Before the move, make sure your refrigerator will fit in the available space with about 1-inch clearance around the top and sides. (This enables proper air circulation, allowing the fridge to work at maximum efficiency.)
3. Empty all food from the fridge and unplug. Do this 24 hours before moving if you have frost buildup in the freezer compartment, so the frost will have time to melt. Wipe up any liquid from the melted frost.
4. Clean the refrigerator interior to minimize odors, especially if the fridge won't be reconnected for some time.
5. Either remove racks, shelves, crispers and storage bins, or fasten securely in place with no-residue tape.
6. If your refrigerator has an automatic icemaker, turn off the house water valve that supplies water to the fridge and then disconnect the water line. Keep a towel handy to wipe up spills.
7. Protect the power cord; tape or tie it onto the back of the refrigerator.
8. Take off the bottom back panel and sponge or Shop-Vac the water from the defrost drain pan so it doesn’t spill. Reinstall the bottom back panel.
Moving the refrigerator
9. Load the fridge with a moving dolly and a helper. It’s okay to tilt the refrigerator when loading, but avoid laying it on its side (not good) or back (much worse) for the actual move. This minimizes possible damage to the sealed system that would cause serious cooling problems later.
10. Secure the refrigerator with cargo straps to keep in position during transit. Hold the doors closed using rope or plastic tape. Cover the front and sides of the fridge with padding to prevent scratches.
11. If you remove the refrigerator door to fit through the kitchen door (at either end of the move), secure all trim, hinges, screws and other hardware in the refrigerator so you don’t lose them.
Installing the refrigerator in its new home
14. Slide the refrigerator into place. Push the top of each front corner back and forth; if the fridge rocks, adjust the leveling feet. Open the doors halfway and then let go. If they swing shut too quickly or don’t close at all, adjust the feet so the refrigerator cabinet front is a quarter inch (or half bubble on a level) higher than the back.
15. Purge air from the water lines by running water through the water dispenser for a short time until the flow is smooth.
Before storing food or making ice
16. If you absolutely had to lay the fridge on its side for transport, let it stand upright the same amount of time before plugging it in. (For example, if the fridge was on its side 2 hours, leave it upright and disconnected for another 2 hours.)
17. After the refrigerator is in place and plugged in, set the controls and let run for 24 hours, to allow it to cool to an optimal temperature, before putting food inside.
18. Give the icemaker 48 hours to start producing ice. Dispose of the first two or three batches in case dirt got into the ice mold or water lines during the move.